Explore the different parts of your product below

Key Components

External layer that provides structural integrity and protection to the contents of the luggage.
This includes the film coating on luggage if applied. The outer shell excludes logo, binding, handles, lock, and any other accessories.

Exterior covering or fabric of the product that provides protection to the contents inside.
This excludes minimal, non-visible coating and backing. Visible coating is included in the calculation.
If made from more than one material, all materials need to be taken into account in the calculation.
If handles, straps, or pockets on the product are the same material as the main body fabric, it will be included in this outer fabric component.
No additional features included - simply the main exterior component. Excludes zipper, mesh, air mesh, or any other accessory.

Material or fabric used to cover the inner surface of a bag including but not limited to partitions, dividers, pockets.
This excludes any accessories or attachments such as mesh, binding, compression straps, buckles, and wet pockets. This also excludes structural frames and backing.

The retractable mechanism built into luggage, allowing users to easily tow or roll the luggage behind them.
Includes the trolley tubes, bezel, handle, and interior support mechanisms (including brace, bracket)
This excludes screws and rivets used to affix the handle system to the bag

Wheels: the rolling components attached to the bottom of the luggage. This includes the inner and outer wheel housing,the wheel tire, wheel axle, fork, plastic bushing, and hub cap.
Zippers: The interlocking closure mechanism used to secure the main compartment and any other compartment of the luggage. This includes the teeth, tape, puller and slider.
Lock: Mechanism used to secure a bag.
Structural elements: Various elements in between the outer fabric and the lining, providing structure to the product. These can vary from product to product and can include backing material, steel wire, foam, PP board, PE board, EVA backing, non-woven.

*For all components, fasteners are included aside from those that hold the component to the main body of the product